|
Post by cpuwiza on Feb 9, 2011 17:57:25 GMT -5
Hi all, I am trying to get a hall effect sensor to act as a pot but I'm having trouble. Instead of moving through the range it just jumps from one side to the other. Suggestions?
|
|
|
Post by Flight Sim Electronics on Feb 9, 2011 20:07:43 GMT -5
Hi all, I am trying to get a hall effect sensor to act as a pot but I'm having trouble. Instead of moving through the range it just jumps from one side to the other. Suggestions? Hi cpuwiza, Could you tell us what brand/model H.E.S. you are using? It sounds as if you are using a latch sensor type instead of a ratiometric type. If that is the case then think of it more as a switch rather than a pot. We currently only carry the ratiometric type for this reason.
|
|
|
Post by cpuwiza on Feb 10, 2011 14:49:28 GMT -5
Yeah I was reading about it further and you're right, it's a latch type. That's what I get for not ordering it from FSE! lol
|
|